AEG S74010KDX0 User Manual page 12

12 www.aeg.com
Problem
Water flows inside
the refrigerator.
Water flows on the
ground.
The temperature in
the appliance is too
cold.
The temperature in
the appliance is too
warm.
The temperature in
the refrigerator is
too warm.
The appliance does
not operate.
Possible cause
The door is not closed
correctly.
The door has been
opened too frequently.
The food temperature is
too high.
The room temperature is
too high.
The water outlet is clog-
ged.
Food prevent that water
flows into the water col-
lector.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The Temperature regula-
tor may be set incorrectly.
The Temperature regula-
tor may be set incorrectly.
The door is not closed
correctly.
The food temperature is
too high.
There is no cold air circu-
lation in the appliance.
Large quantities of food
to be cooled were put in
at the same time.
The appliance is switched
off.
The mains plug is not
connected to the mains
socket correctly.
The appliance has no
power. There is no volt-
age in the mains socket.
Solution
Refer to "Closing the
door".
Do not keep the door
open longer than necessa-
ry.
Let the food temperature
decrease to room temper-
ature before storage.
Decrease the room tem-
perature.
Clean the water outlet.
Make sure that food do
not touch the rear plate.
Attach the melting water
outlet to the evaporative
tray.
Set a warmer temperature.
Set a lower temperature.
Refer to "Closing the
door".
Let the food temperature
decrease to room temper-
ature before storage.
Make sure that there is
cold air circulation in the
appliance.
Insert smaller quantities of
food to be cooled at the
same time.
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a another electri-
cal appliance to the mains
socket. Check fuse. Con-
tact a qualified electrician.