Throttle Friction Adjuster; Engine Stop Lanyard Switch - Yamaha 250G Owner's Manual

Basic components
2
3
1
1. Fully open
2. Fully closed
3. Free accelerator
NOTE:
The free accelerator button can only be
G
used when the remote control lever is in
the neutral position.
After the button is pushed, the throttle be-
G
gins to open after the remote control lever
is moved at least 35°.
After using the free accelerator, return the
G
remote control lever to the neutral position.
The free accelerator button will return au-
tomatically to its set position. The remote
control will then engage forward and re-
verse normally.
EMU25970

Throttle friction adjuster

A friction device provides adjustable resis-
tance to movement of the throttle grip or the
remote control lever, and can be set accord-
ing to operator preference.
To increase resistance, turn the adjuster
clockwise. To decrease resistance, turn the
adjuster counterclockwise.
EWM00030
WARNING
Do not overtighten the friction adjuster. If
there is too much resistance, it could be
difficult to move throttle lever or grip,
9
which could result in an accident.
ZMU04575
When constant speed is desired, tighten the
adjuster to maintain the desired throttle set-
ting.
EMU25990

Engine stop lanyard switch

The lock plate must be attached to the en-
gine stop switch for the engine to run. The
lanyard should be attached to a secure place
on the operator's clothing, or arm or leg.
Should the operator fall overboard or leave
the helm, the lanyard will pull out the lock
plate, stopping ignition to the engine. This
will prevent the boat from running away un-
der power.
EWM00120
WARNING
Attach the engine stop switch lanyard
G
to a secure place on your clothing, or
ZMU04646