Reverse (Automatic Reverse Lock And Power Trim And Tilt Models); Stopping Engine; Procedure - Yamaha 250G Owner's Manual

Operation
EMU27784
Reverse (automatic reverse lock and
power trim and tilt models)
EWM00190
WARNING
When operating in reverse, go slowly. Do
not open the throttle more than half. Oth-
erwise the boat could become unstable,
which could result in loss of control and
an accident.
Tiller control models
1. Place the throttle grip in the fully closed
position.
2. Move the gear shift lever quickly and
firmly from neutral to reverse.
Remote control models
1. Pull up the neutral interlock trigger (if
equipped) and move the remote control
lever quickly and firmly from neutral to
reverse.
33
N
R
ZMU04598
EMU27820

Stopping engine

Before stopping the engine, first let it cool off
for a few minutes at idle or low speed. Stop-
ping the engine immediately after operating
at high speed is not recommended.
EMU27851

Procedure

1. Turn the main switch to "
ON
OFF
2. After stopping the engine, disconnect
the fuel line or close the fuel cock if there
is a fuel joint or a fuel cock on the boat.
3. Tighten the air vent screw on the fuel
tank cap (if equipped).
4. Remove the key if the boat will be left
unattended.
NOTE:
The engine can also be stopped by pulling
the lanyard and removing the clip from the
engine stop switch, then turning the main
" (off).
ON
OFF
ZMU04600