Yamaha GRIZZLY 125 YFM125GZ Owner's Manual page 79

Table of Contents

Advertisement

To check the engine oil level
1. Place the ATV on a level surface.
2. Check the engine oil level on a cold engine.
TIP
If the engine was started before checking the oil
level, be sure to warm up the engine sufficiently,
and then wait at least ten minutes until the oil set-
tles for an accurate reading.
3. Remove the engine oil filler cap, and then
wipe the engine oil dipstick off with a clean
rag.
1. Engine oil tank filler cap
2. Dipstick
1
2
8-10
4. Insert the dipstick into the filler hole (without
screwing it in), and then remove it again to
check the oil level.
1. Maximum level mark
2. Minimum level mark
TIP
The engine oil should be between the minimum
and maximum level marks.
5. If the engine oil is at or below the minimum
level mark, add sufficient oil of the recom-
mended type to raise it to the correct level.
NOTICE: Be sure the engine oil is at the
correct level, otherwise engine damage
1
2
1
3
2
4
5
6
7
8
9
10
11

Advertisement

Table of Contents
loading

Table of Contents