Yamaha YZF-R1 Owner's Manual page 25

●
a self-diagnosis device
● a display brightness and shift tim-
ing indicator light control mode
TIP
●
Be sure to turn the key to "ON" be-
fore using the "SELECT" and "RE-
SET" buttons, except for setting
the display brightness and shift
timing indicator light control mode.
● For the U.K. only: To switch the
speedometer and odometer/trip-
meter/fuel consumption displays
between kilometers and miles,
press the "SELECT" button for at
least one second.
Tachometer
1
1. Tachometer
2. Tachometer red zone
INSTRUMENT AND CONTROL FUNCTIONS
The electric tachometer allows the rider
to monitor the engine speed and keep it
within the ideal power range.
When the key is turned to "ON", the ta-
chometer needle sweeps once across
the r/min range and then returns to zero
r/min in order to test the electrical cir-
cuit.
NOTICE
Do not operate the engine in the ta-
chometer red zone.
Red zone: 13750 r/min and above
Clock and stopwatch modes
2
1. Clock/stopwatch
To set the clock
1. Push the "SELECT" button and
2. When the hour digits start flashing,
3. Push the "SELECT" button, and
ECA10031
4. Push the "RESET" button to set
5. Push the "SELECT" button and
To display the stopwatch
To change the display to the stopwatch
mode, push the "SELECT" button and
"RESET" button together. To change
the display back to the clock mode,
push the "SELECT" button and "RE-
SET" button together; however, this is
not possible when the stopwatch is
counting.
1
Standard measurement
1. Push the "RESET" button to start
2. Push the "SELECT" button to stop
3-10
"RESET" button together for at
least two seconds.
push the "RESET" button to set the
hours.
the minute digits start flashing.
the minutes.
then release it to start the clock.
the stopwatch.
the stopwatch.
3