2
4
4. Install:
• Exhaust pipe protector
Exhaust pipe protector screw
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
LOCTITE®
EAS1SM1084
CHECKING THE FUEL LINE
1. Remove:
• Seat
• Side cover (left/right)
• Air scoop (left/right)
Refer to "GENERAL CHASSIS" on page 4-
1.
• Fuel tank
Refer to "FUEL TANK" on page 7-1.
2. Check:
• Fuel hose "1"
Crack/damage Replace.
Loose connection Connect properly.
3. Install:
1
CHECKING THE ENGINE OIL LEVEL
EAS1SM1085
1. Stand the vehicle upright on a level surface.
2. Start the engine, warm this up for 2–3 min-
3. Check:
3
ECA33DD018
NOTICE
• Since engine oil also lubricates the clutch,
• Do not allow foreign material to enter the
1
3-14
• Fuel tank
Refer to "FUEL TANK" on page 7-1.
• Air scoop (left/right)
• Seat
• Side cover (left/right)
Refer to "GENERAL CHASSIS" on page 4-
1.
utes, and then stop the engine and wait
about 5 minute.
• Oil level
The engine oil level should be between the
minimum level mark "a" and maximum level
mark "b".
Below the minimum level mark Add the
recommended engine oil to the proper level.
b
a
the wrong oil types or additives could
cause clutch slippage. Therefore, do not
add any chemical additives.
crankcase.
Recommended brand
YAMALUBE
Recommended engine oil type
SAE10W-30, SAE10W-40,
SAE10W-50, SAE15W-40,
SAE20W-40 or SAE20W-50
Recommended engine oil grade
API service SG type or higher,
JASO standard MA
ENGINE