Setup; Installing The Roller; Installing The Ball Studs; Installing The Hoop Link, Offset Link, Or Chain Link - Toro 04652 Operator's Manual

Setup

Media and Additional Parts
Description
Ball stud
Operator's Manual
Parts catalog

Installing the Roller

The cutting unit is shipped without a front roller. Obtain
a roller from your dealer and install it on the cutting unit,
as follows:
1. Remove the plow bolt, washer, and flange nut securing
one of the height-of-cut arms to the cutting unit side
plate (Figure 3).
3
G016936
1. Height-of-cut arm
2. Adjusting screw
3. Plow bolt
2. Loosen the roller-mounting screws in the height-of-cut
arms (Figure 3).
3. Slide the roller shaft into the height-of-cut arm on the
opposite end of the cutting unit
4. Slide the height-of-cut arm onto the roller shaft
3).
5. Loosely secure the roller to the cutting unit with the
height-of-cut arm and fasteners previously removed
(Figure 3).
6. Center the roller between the height-of-cut arms.
2
1
4
5
6
Figure 3
4. Washer
5. Flange nut
6. Roller-mounting screw
(Figure 3).
Qty.
2 Mount this to the roller.
1 Read before installing and operating the cutting unit.
1 Use this to reference part numbers.
7. Tighten the roller-mounting screws
8. Adjust to the desired height-of-cut and tighten the
height-of-cut arm mounting fasteners.

Installing the Ball Studs

Install a ball stud on each end of the front roller
G020075
1. Ball stud
Installing the Hoop Link, Offset
Link, or Chain Link
For cutting units mounting on a traction unit with a serial
number prior to 240000001, obtain and install the proper
lift link as follows:
Note: The 2 bolts used to mount the lift link are shipped
installed on the cutting unit.
•
For Greensmaster 3120 and 3150 traction units, install
the hoop link (Part No. 105-5740) supplied with the
traction unit.
Install the hoop link to the top of the cutting unit with 2
(Figure
bolts. Torque the bolts to 34 to 40 N∙m (25 to 30 ft-lb)
(Figure 5).
5
Use
(Figure 3).
(Figure
Figure 4
4).