Installing The Motion Control Levers; Activating The Battery - Toro 74176 Operator's Manual

3. Place the seat retaining rod to the outside of the
mounting tab of the seat frame and secure with a bolt
(5/16 x 1 inch) bolt and locknut 5/16 inch (Fig. 3).
4. Tighten until snug, then loosen so the rod pivots freely.
2
Figure 3
1. L end of retaining rod
2. Locknut, 5/16 inch
Installing the Motion Control
Levers
There are two positions to install the control levers, high
and low. Install levers in the top and middle holes for the
high position. Install levers in the middle and bottom
holes for the low position.
1. Remove the 4 bolts (3/8 x 1 inch) and 4 spring washers
(3/8 inch) which attach the motion control levers to the
control arm shafts for shipping (Fig. 4).
2. Place the levers (with the mounting plate toward the
rear) on the outside of the control arm shaft and secure
with 4 bolts (3/8 x 1 inch) and 4 spring washers
(3/8 in.) (Fig. 4).
3. Position the levers so the bolts are in the center of the
slots on the lever mounting plate and tighten until
snug.
4. Align the front\rear position of the levers, with each
other, in the neutral position. Loosen hardware and
adjustment by sliding/tilting the lever(s) forward or
backward until properly aligned (Fig. 4).
1
3
m–3750
3. Bolt, 5/16 x 1 inch
15
2
1
3
Figure 4
1. Mounting plate
2. Bolt, 3/8 x 1 inch
3. Spring washer, 3/8 inch
5. If the ends of the levers hit against each other, while in
the drive position (Fig. 5) (levers rotated in as far as
possible) make adjustments by moving the levers
outward to the neutral lock position and carefully bend
them outward. Move them back to the drive position
and check for clearance. Repeat if necessary.
FRONT
OF
UNIT
LEVERS IN
ALIGNMENT
Figure 5

Activating the Battery

Bulk electrolyte with 1.265 specific gravity must be
purchased from a local battery supply outlet.
4
5
6
m–5596
4. Top hole
5. Middle hole
6. Bottom hole