Toro 71241 Operator's Manual page 45

(15.875 mm)
5/8"
1
3
4
Figure 51
1. Adjusting block
2. Long rod
1
1
Figure 52
1. Measure front center
7. To adjust front-to-rear blade slope loosen front
pivot plate mounting bolts slightly (Fig. 53).
2
1889
3. Hairpin cotter and washer
4. Mower mount
2
2. Measure rear center
8. Rotate lock nuts on eyebolts to change
adjustment (Fig. 53). To raise the front of the
mower, tighten the eyebolt lock nuts. To lower
the front of the mower, loosen the eyebolt lock
nuts.
9. After adjusting both eyebolt lock nuts evenly,
check the front-to-rear slope again. Continue
adjusting eyebolts until the front blade tip is
0–3/8" (0–9.2 mm) lower than the rear blade tip
(Fig. 53).
10. When front-to-rear slope is correct, tighten the
pivot plate mounting bolts (Fig. 53).
1. Pivot mounting bolt
2
11. When front-to-rear slope is correct, recheck the
side-to-side level of the mower; refer to
Side-to-Side Mower Leveling, page 41.
1892
Maintenance
1
2
1
Figure 53
2. Eyebolt locknut
43