Toro 03530 Operator's Manual page 38

Maintenance
FUSES
IMPORTANT
USE CORRECT FUSES.
WRONG FUSES CAN CAUSE
DAMAGE TO CONTROLLER
AND VOID WARRANTY.
CONTROLLER
LOGIC
4A
ACCESSORY
POWER
7.5A
OPTIONAL
LIGHTS
10A
OPEN
BACKLAPPING
DANGER
Reels may stall while backlapping. Do not attempt
to restart reels by hand or while backlapping. Stop
the engine and turn the height of cut knob one
position toward "A".
Note: When backlapping, the front units all operate
together, and the rear units operate together.
1. Position the machine on a level surface, lower
the cutting units, stop the engine, engage the
parking brake, and move the Enable/Disable
switch to the Disable position.
2. Unlock and raise the seat to expose controls.
3. Open the control cover and turn the height-of-
cut selection knob to position "P".
38
CONTROLLER
POWER
10A
IGNITION
SWITCH
20A
CONTROLLER
POWER
10A
CONTROLLER
POWER
10A
94-6766
4. Make initial reel-to-bedknife adjustments appro-
priate for backlapping on all cutting units that
are to be backlapped.
5. Start the engine and run at idle speed.
To avoid personal injury, never place hands
or feet in the reel area while the engine is run-
ning. Changing engine speed while backlap-
ping may cause reels to stall. Never change
engine speed while backlapping. Only back-
lap at idle engine speed. Never attempt to
turn reels by hand or foot while the engine is
running.
6. Select either the front or rear on the backlap
switch to determine whether the front or rear
reels will be backlapped.
7. Move Enable/Disable switch to the Enable posi-
tion. Move the Lower Mow / Lift control for-
ward to start back-lapping operation on desig-
nated reels.
To avoid personal injury, be certain that you
are clear of the cutting units before proceed-
ing.
8. Apply lapping compound with the long handle
brush supplied with the machine. Never use a
short-handled brush.
9. If the reel to be backlapped turns too slowly, or
erratically, stop the engine and turn height-of-
cut knob one position toward "A". Repeat steps
5–9. (Position "P" will provide the slowest
speed for backlapping. Position "A" will pro-
vide the fastest speed for backlapping. New
motors will generally backlap at position "P",
but with time, the set point may need to be
moved closer to "A" to account for motor wear.)
10. To make an adjustment to the cutting units
while backlapping, turn the reels OFF by mov-
ing the Lower Mow/Raise lever rearward; move
the Enable/Disable switch to Disable and turn
the engine OFF. After adjustments have been
completed, repeat steps 5–9.
DANGER
DANGER