Toro 03530 Operator's Manual page 19

the height-of-cut selector knob may be set to position
"A", which will direct the machine controller to run
the reels at full speed at all times. Also, set the
height-of-cut selector knob to position "A" when
troubleshooting the electrical system.
1. Height -of- cut selector knob
8-Blade Cutting Unit
Height of Cut Knob
Position
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
FULL SPEED—Cutting units always set to full speed in this position.
Figure 17
CLIP RATE (REEL SPEED) SELECTIONS CHART
Height of Cut
Full Speed
6.4 mm
7.6 mm
8.9 mm
10.2 mm
11.4 mm
12.7 mm
14.0 mm
15.2 mm
16.5 mm
17.8 mm
19.0 mm
20.3 mm
21.6 mm
22.9 mm
24.1 mm
REEL CONTROL LIGHT
The reel control light on the front control panel is
used to tell the operator that the machine controller is
able to achieve the desired clip. If the machine is
operated at a traction speed which is too low or too
high, the machine controller may not be able to set
the reel speed at the required value to achieve the
desired clip. If this occurs, the reel control light will
illuminate.
If the reel control light illuminates, it means one of
the following things:
1. The machine is being operated at a traction
speed too slow to allow desired clip.
2. The machine is being operated at a traction
speed too fast to allow desired clip. To correct
the situation, change the traction speed until the
light goes out.
5-Blade Cutting Unit
Height of Cut Knob
Position
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Operating Instructions
Height of Cut
Full Speed
12.7 mm
14.0 mm
15.2 mm
16.5 mm
17.8 mm
19.0 mm
20.3 mm
21.6 mm
22.9 mm
24.0 mm
25.4 mm
27.0 mm
30.0 mm
33.0 mm
36.0 mm
19