Toro 03530 Operator's Manual page 16

Controls
Charge Indicator (Fig. 11)—Illuminates when sys-
tem charging circuit malfunctions.
Key Switch (Fig. 11)—Three positions: OFF,
ON/Preheat and START.
Throttle Control (Fig. 11)—Move the control for-
ward to increase engine speed, rearward to decrease
speed.
Enable/Disable Switch (Fig. 11)—Used in conjunc-
tion with lower mow / raise the control lever to oper-
ate reels.
Reel Control Light (Fig. 11)—When lit, indicates
the machine is being operated in a way in which the
automatic reel speed control cannot obtain the
desired clip.
Backlap Switch (Fig. 12)—Used with lower mow /
Figure 12
1. Backlap Switch
lever for backlapping operation.
Height-of-Cut Selector Knob (Fig. 13)—Turning
the knob to the appropriate setting informs the elec-
tronic controller at what height of cut the machine is
being operated so desired clip may be obtained.
Hour Meter (Fig. 13)—Shows the total hours the
machine has been operated.
Brake Pedals (Fig. 14)—Two foot pedals operate
individual wheel brakes for turning assistance, park-
16
1. Height- of-Cut Selector Knob
2. Hour Meter
ing and to aid in sidehill traction. A Locking pin
connects the pedals for parking brake operation and
transport.
Parking Brake Latch (Fig. 14)—A knob on the left
side of the console actuates the parking brake lock.
To engage the parking brake, connect the pedals with
the locking pin, push down on both pedals and pull
the parking brake latch out. To release the parking
brake, depress both pedals until the parking brake
latch retracts.
raise
con-
trol
1. Brake Pedals
2. Parking Brake Latch
3. Locking Pin
Figure 13
Figure 14