Toro 04530 Operator's Manual page 31

Note: A "click" can be heard and felt when the latches
are properly locked in place.
6. Coat the spline shaft of the cutting unit motor with
clean grease (Figure 35).
7. Insert the motor into the left side of the cutting unit
(as viewed from the operator's position) and pull the
motor retaining bar on the cutting unit toward the
motor until you hear an audible "click" from both sides
of the motor (Figure 35).
1. Reel motor
2. Spline shaft
8. Mount a grass basket onto the basket hooks on the
suspension arm.
9. Repeat this procedure for the other cutting units.
10. Connect the cutting unit power disconnect couplers;
refer to Cutting Unit Power Disconnect (page 25).
Removing the Cutting Units
1. Disconnect the cutting unit power disconnect couplers;
refer to Cutting Unit Power Disconnect (page 25).
CAUTION
If you do not disconnect the power to the
cutting units, someone could accidentally
start the cutting unit, causing serious injury
to hands and feet.
Always separate the cutting unit power
disconnect couplers before working on the
cutting units.
Figure 35
3. Cavity
4. Motor retaining bar
2. Park the machine on a clean level surface, lower
the cutting units to the ground until the suspension
hydraulics are fully extended, stop the engine, and set
the parking brake.
3. Push the motor retaining bar out of the slots on the
motor towards the cutting unit and remove the motor
from the cutting unit.
1. Reel motor
4. Move the motor to the storage location on the front of
the suspension arm (Figure 37).
Note: When sharpening, setting the height-of-cut,
or performing other maintenance procedures on the
cutting units, store the cutting unit reel motors in the
storage location on the front of the suspension arms to
prevent damage to them.
Important: Do not raise the suspension to the
transport position when the reel motors are in the
holders in the machine frame. Damage to the
31
Figure 36
2. Motor retaining bar
Figure 37