Toro 04530 Operator's Manual page 16

CAUTION
If you do not disconnect the power to the
cutting units, someone could accidentally
start the cutting unit, causing serious injury
to hands and feet.
Always separate the cutting unit power
disconnect couplers before working on the
cutting units.
2. Apply grease to the inside diameter of the drive coupler.
3. The cutting unit is shipped without a front roller.
Obtain a roller (Model No. 04625, 04626 or 04627)
from your local Toro Distributor. Install the roller
using the loose parts supplied with the cutting unit and
installation instructions included with the roller.
4. Remove the 2 bolts securing the weight to the side of
the cutting unit (Figure 11).
2 3
1
Figure 11
1. Cutting until weight (flip
over)
2. Upper weight
5. Rotate the weight 180 degrees so that the open screw
holes that were on the underside of the weight are now
on top. Install the weight to the cutting unit using the
bolts removed previously.
6. Install an upper weight to the cutting unit weight using
2 hex head screws (Figure 11).
7. If installing the center cutting unit, lift up on the foot
rest and swing it up, allowing access to the center
cutting unit position (Figure 12).
g016294
3. Hex head screws
CAUTION
The foot rest can pinch fingers if it falls into
the closed position.
Keep your fingers clear of the area where the
foot rest seats while it is open.
1
1. Footrest—closed
8. Position the cutting unit under the suspension arm.
9. With the latches on the suspension-arm bar pointing
up (i.e., open) (Figure 13), push the suspension arm
down so that the bar fits over the bar across the top of
the cutting unit (Figure 14).
1. Latch—closed position
2. Suspension-arm bar
16
2
Figure 12
2. Footrest—open
1
2
Figure 13
3. Latch—open position
g014602
3
g014609