Draining Gasoline And Cleaning Fuel Filter; Engine Oil - Toro 22172 Operator's Manual

Recycler walk-behind power mower
Hide thumbs Also See for 22172:
Table of Contents

Advertisement

Draining Gasoline and
Cleaning Fuel Filter
Clean the fuel filter element every 50 hours of operation.
1. Stop the engine and wait for it to cool.
IMPORTANT: Drain gasoline from a cold engine only.
2. Pull the wire off of the spark plug (Fig. 5).
3. Remove the fuel tube by loosening the tube clamp at
the carburetor (Fig. 17).
2
Figure 17
1. Fuel tube
4. Open the fuel valve by turning the lever to the open
position (Fig. 6).
5. Drain gasoline completely from the tank and fuel line
into an approved gasoline container.
6. Remove the fuel tube on the fuel tank by loosening the
tube clamp (Fig. 18).
7. Remove the fuel filter from the fuel tank (Fig. 18).
Figure 18
1. Fuel tube
8. Clean the fuel filter with high flash-point solvent.
9. Firmly reinstall the filter, tubes and clamps.
1
2. Tube clamp
2
1
2. Fuel filter

Engine Oil

Change the engine oil after the first 8 hours of operation
and after 50 hours of operation or yearly thereafter.
1. Run the engine to warm the oil.
WARNING
POTENTIAL HAZARD
Oil may be hot after engine has been run.
WHAT CAN HAPPEN
Contact with hot oil can cause severe personal
injury.
HOW TO AVOID THE HAZARD
Avoid contact with oil while draining oil.
2. Stop the engine and pull the wire off of the spark plug
(Fig. 5).
3. Place a suitable drain pan under the side oil drain plug.
4. Raise the left side of the mower at least 12 inches and
open the side oil drain plug (Fig. 19).
2
Figure 19
1. Side oil drain plug
5. Insert the oil drain tube over the drain plug and lower
mower (Fig. 19).
6. Raise right side of mower until all oil has flowed into
the drain pan.
7. Remove the oil drain tube and retighten the side oil
drain plug.
IMPORTANT: Do not over-tighten the side oil drain
plug. It may cause damage to the crankcase cover.
Specified torque is 23 N-m (190 in-lbs.).
8. Recycle the oil as per local codes.
9. Fill the crankcase to the FULL line on the dipstick
with fresh oil. Refer to the Oil section, page 6, for
specifications.
10. Wipe up any spilled oil.
14
1
m-4354
2. Oil drain tube

Advertisement

Table of Contents
loading

Table of Contents