Safety And Instruction Decals; Assembly; Install Handle - Toro 22172 Operator's Manual

Safety and Instruction Decals

Safety decals and instructions are easily visible to the operator and are located near any
area of potential danger. Replace any decal that is damaged or lost.
ON CONTROL PANEL
(Part No. 63-9060)
ON BELT COVER
(Part No. 52-2620)
ON DISCHARGE TUNNEL

Assembly

Install Handle

1. Mount handle to outside of mower housing, using
bottom hole, with (2) 5/16–18 x 1–1/4" lg. capscrews,
washers, and thin nylon insert locknuts (Fig. 1).
2. Secure handle latches to handle with (2)
5/16–18 x 1–1/2" lg. capscrews, washers and nylon
insert locknuts (Fig. 1).
Note: Handle height is adjustable for operator comfort.
Stand behind mower handle to gauge height. To adjust
handle height, reposition capscrews and locknuts securing
handle latches to handle into other mounting holes in
latches.
3. Slide bag support rod thru top mounting holes in
handle and secure each end with a cap locknut (Fig. 1).
4. Use a cable tie to secure the control cables to left
handle below the bag support rod.
ON BELT COVER
(Part No. 74-1970)
ON PLUG
ON CONTROL PANEL
(Part No. 85-6730)
4
1. Bag support rod
2. Cap locknut
5
ON MOWER HOUSING
(Part No. 43-8480)
1
2
3
Figure 1
3. Handle
4. Handle latch
m–3850