Table of Contents
Advertisement
Figure 29
1. Grease fitting
2. Install a grease gun onto each fitting in turn and gently
apply one or two pumps of #2 multi-purpose lithium
grease to each.
IMPORTANT: Excess grease may damage seals and
prevent proper wheel clutch operation.
Lubricating the Gear Case
After every 100 operating hours, grease the gear case with
#2 Multi-Purpose Lithium Base Grease.
1. Install grease gun onto fitting through belt cover
opening (Fig. 30). Gently apply 1-2 pumps of grease.
1
Figure 30
1. Grease fitting
Cleaning the Underside of the
Mower Housing
To ensure best performance, keep the underside of the
mower housing clean. Be especially careful to keep the
kickers free of debris (Fig. 31).
1
232
1. Kicker plates
Washing Method
1. Position the mower on a flat, concrete or asphalt
2. Start the engine.
3. Hold the running garden hose at handle level and
1. Rear right wheel
4. Stop the engine.
224
5. Turn off the garden hose.
6. Start the mower and let it run for a few minutes to dry
7. While the engine is running, engage and disengage the
Scraping Method
If washing does not remove all debris from under the
mower, tip it and scrape it clean.
1. Pull the wire off of the spark plug (Fig. 5).
18
Figure 31
surface near a garden hose.
direct the water to flow on the ground just in front of
the right rear tire (Fig. 32).
The blade will draw in water and wash out clippings.
Let the water run until you no longer see clippings
being washed out from under housing.
Figure 32
out the moisture on the mower and its components.
traction drive several times to dry it out.
796
1
1093
Advertisement
Table of Contents
