Allied Telesis AT-8624PoE Installation And Safety Manual page 9

Installation & Safety Guide
6. Place the switch in its operating location
If installing the switch in a rack:
•
•
•
7. Check the supply voltage and the switch's rated voltage
AT-8600 Series switches are fitted with a universal main power supply that
will function over the range 100–240 VAC and 50–60 Hz.
The specific power supply requirements for a particular model are clearly
displayed on the rear or underside of the switch. If the supply is outside the
accepted range for the switch, the switch may not operate or damage to
the switch may result.
8. Apply AC power to the switch
Plug the power cord into the AC power connector on the switch's rear
panel as shown in Figure 1. The Fault LED should flash for approximately 10
seconds as the switch runs internal tests. If the LED continues to flash,
refer to the AT-8600 Series Hardware Reference for troubleshooting
information.
Figure 1: AT-8624T/2M front and rear panel with AC power inlet.
25
Figure 2: AT-8624PoE front and rear panel with AC power inlet
25
Remove the rubber feet on the bottom of the switch with a flat-head
screwdriver.
Attach the two rack-mounting brackets to the switch with the screws
provided.
Mount the switch in the rack using standard screws (these are not
provided).
1 3 5 7 9
26
2 4 6 8 10
1 3 5 7 9
26
2 4 6 8 10
11 13 15 17 19 21 23
12 14 16 18 20 22 24
11 13 15 17 19 21 23
12 14 16 18 20 22 24
AT-8624T/2M
Advanced Fast Ethernet Switch
MODE RS-232
1 3 5 7 9 11 13 15 17 19 21 23
TERMINAL PORT
LINK COL
MODE 100
LINK FULL
MODE ACT
2 4 6 8 10 12 14 16 18 20 22 24
100 LINK ACT 10 LINK ACT
AT-8624POE
FULL DUP HALF DUP COL Layer 3 Fast Ethernet Switch
PD ON PD ERR MAX CURRENT
MODE RS-232
1 3 5 7 9 11 13 15 17 19 21 23
TERMINAL PORT
2 4 6 8 10 12 14 16 18 20 22 24
9
STATUS
FAULT
MASTER
RPS
PWR
STATUS
FAULT
MASTER
RPS
PWR