Allied Telesis AT-8624PoE Installation And Safety Manual page 12

12
To change the account password, use the command:
To display a list of help topics, use the command:
To display help on a specific topic, use the command:
Alternatively, type a question mark (?) at the end of a partially completed
command to see a list of valid options.
How to configure the switch is explained in detail in the AT-8600 Series Software
Reference.
Using the GUI to configure a switch
This section describes how to establish a connection to the switch through the
GUI, so you can configure the switch before installing it in your LAN.
1. Select a PC to browse to the
You can browse to the switch from any PC that is running a supported
operating system with a supported browser installed. JavaScript must be
enabled. If you are using a toolbar or plug-in on your browser to block pop-
ups, disable it while using the GUI. The GUI displays detailed configuration
options and information in pop-up windows.
You need to know the PC's subnet.
2. Connect the PC to the
Use an Ethernet cable to connect an Ethernet card on the PC to any one of
the switch ports.
Note You can browse to the router through any VLAN, as long as you give that
VLAN an IP address (see below). These instructions assume you will use vlan1.
The switch ports all belong to vlan1 by default.
3. Access the
Access the CLI from the PC, as described in the previous "Using the CLI to
configure a switch" section.
set password
help
help topic
switch
's command line interface
switch
from
switch
AT -8600 Series Switch