Positioning The Seat; Adjusting The Motion Control Levers; Pushing The Machine By Hand - Toro 74390 Operator's Manual

g019929
1. Anti-scalp roller
2. Lower hole—the mower
deck in the 76mm (3 inch)
and above height-of-cut
positions
3. Flange Nut

Positioning the Seat

1. Raise the seat and loosen the adjustment bolts just
enough that seat can move (Figure 23).
1
1. Adjustment bolt
2. Move the seat to the desired position and tighten the
bolts.
Adjusting the Motion Control
Levers
Adjusting the Height
The motion control levers can be adjusted higher or lower for
maximum operator comfort.
1. Remove the 2 bolts holding the control lever to the
control arm shaft (Figure 24).
4
5
Figure 22
4. Upper hole—the mower
deck in the 63mm
(2-1/2 inch) and below
height-of-cut positions
5. Bolt
G014477
Figure 23
2. Move the control lever to the next set of holes. Secure
the lever with the 2 bolts (Figure 24).
G014970
1. Control arm shaft
2. Control lever
3. Repeat the adjustment for the opposite control lever.
Adjusting the Tilt
The motion control levers can be tilted fore or aft for
maximum operator comfort.
1. Loosen the upper bolt holding the control lever to the
control arm shaft.
2. Loosen the lower bolt just enough to pivot the control
lever fore or aft (Figure 24). Tighten both bolts to
secure the control in the new position.
3. Repeat the adjustment for the opposite control lever.

Pushing the Machine by Hand

Important: Always push the machine by hand. Never
tow the machine because damage may occur.
This machine has an electric brake mechanism and to push
the machine the ignition key needs to be in the Run position.
The battery needs to be charged and functioning for the
electric brake to be disengage.
To Push the Machine
1. Park the machine on a level surface and disengage the
blade control switch.
2. Move the motion control levers outward to park
position, stop the engine, and wait for all moving parts
to stop before leaving the operating position.
3. Locate the bypass levers on the frame on both sides of
the engine.
4. Move the bypass levers forward through the key hole
and down to lock them in place as shown inFigure 25 .
Ensure this is done for each lever.
5. Move the motion control levers inward to the neutral
position and turn the ignition key to the run position.
Do not start the machine.
21
2
1
3
4
Figure 24
3. Slotted, upper hole
4. Bolt