Premaintenance Procedures; Raising The Seat; Lubrication; Greasing The Bearings - Toro 74390 Operator's Manual

Premaintenance
Procedures

Raising the Seat

Make sure the motion control levers are locked in the park
position. Lift the seat forward.
The following components can be accessed by raising the seat:
•
Serial plate
•
Service decal
•
Seat adjustment bolts
•
Fuel filter
•
Battery and battery cables

Lubrication

Greasing the Bearings

Service Interval: Every 25 hours—Grease all lubrication
points.
Grease Type: No. 2 General Purpose Lithium Base Grease
1. Park the machine on a level surface and disengage the
blade control switch.
2. Move the motion control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3. Clean the grease fittings (Figure 28) with a rag. Make
sure to scrape any paint off of the front of the fitting(s).
1. Front caster tire
4. Connect a grease gun to each fitting (Figure 28). Pump
grease into the fittings until grease begins to ooze out
of the bearings.
5. Wipe up any excess grease.
26
1
G014522
Figure 28