Lubricating The Upper Handle - Toro 20897 Operator's Manual

Figure 41
•
If the oil level is too low, slowly pour a small
amount of oil into the oil-fill tube, wait 3 minutes,
and then repeat steps
level is at the Full mark on the dipstick.
•
If the oil level is too high, drain the excess oil until
the oil level is correct as shown in
Important: If the oil level in the crankcase is too
low or too high and you run the engine, you may
damage the engine.
13. Install the dipstick into the oil-fill tube securely.
14. Dispose of the used oil properly at a local recycling
center.
10 through 12 until the oil
Figure 41.

Lubricating the Upper Handle

Service Interval: Yearly
Lubricate the left and right sides of the upper handle with a
low-viscosity silicone spray lubricant.
1. Spray the outer plastic end of the inner handle
42).
Note: Use the straw that comes with the spray can to
direct the spray.
2. Push the upper handle fully down and spray the inner
plastic surface of the outer handle
18
Figure 42
(Figure 43).
Figure 43
(Figure