Energy Management; At The End Of The Programme - Miele G 6860 Operating Instructions Manual

Operation

Energy management

To save energy, the dishwasher will
switch off automatically 10 minutes
after the last time a button has been
pressed or 10 minutes after the end of
the programme (see "Settings menu,
Optimise standby").
 Press the  button to switch the
dishwasher back on.
The dishwasher will not switch off
whilst a programme or the FlexiTimer
is running or if there is a fault.

At the end of the programme

At the end of a programme, the In-oper-
ation indicator light will be visible flash-
ing slowly with the door shut. The
buzzer might also be sounding.
The In-operation indicator light will go
out 10 minutes after the end of the pro-
gramme if the door is closed.
The programme has finished when the
door has opened slightly (if applicable)
and 
Finished appears in the display.
In the QuickPowerWash
door will not open until a few minutes
after the programme has finished.
If the Consumption
tion is switched on, you can now call up
the actual energy and water consump-
tion of the programme which has just
finished (see "Caring for the environ-
ment, EcoFeedback consumption indic-
ator").
The drying fan may continue to run for
a few minutes at the end of the pro-
gramme.
50
programme the
programmable func-
 Open the door completely to re-en-
gage the door closing mechanism.
You can now empty the dishwasher.

If you have deactivated the auto-
matic door opening function (see
"Settings menu, AutoOpen"), but
would still like to open the door at
the end of the programme, then
make sure that you open the door
fully.
Otherwise steam from the dish-
washer could damage the edge of
the worktop because the fan is no
longer running.