Table of Contents
Advertisement
1
2
3
1. Flange Nut
2. Anti-scalp roller
1
g024243
1. Bolt
2. Bushing
Adjusting the Skid(s)
Mount the skids in the lower position when operating in
height of cuts higher than 64 mm (2-1/2 inches) and in the
higher position when operating in height of cuts lower than
64 mm (2-1/2 inches).
Note: When the skids become worn, switch the skid to the
opposite sides of the mower, flipping them over. This will
allow you to use the skids longer before replacing them.
1. Disengage the PTO and set the parking brake.
4
g024242
Figure 27
3. Bushing
4. Bolt
2
3
Figure 28
3. Anti-scalp roller
4. Flange Nut
2. Move the throttle lever to the Slow position, stop the
engine, remove the key, and wait for all moving parts to
stop before leaving the operating position.
3. Remove the carriage bolts and nuts from each skid
(Figure 29).
1
g024244
1. Carriage bolt
2. Skid
4. Move each skid to the desired position and secure them
with the carriage bolts and nuts.
Note: Only use the top or center sets of holes to
adjust the skids. The bottom holes are used when
4
switching sides on the mower deck, at which time they
become the top holes on the other side of the mower.
5. To prevent damaging the skid, torque the carriage bolts
and nuts for each skid to 12.4 to 14.7 N-m (110 to 130
in-lb).
Positioning the Seat
The seat can move forward and backward. Position the seat
where you have the best control of the machine and are most
comfortable.
To adjust, move the lever sideways to unlock seat (Figure 30).
g019754
23
2
3
Figure 29
3. Nut
Figure 30
Advertisement
Table of Contents
