Inspecting The Blades; Removing The Blade - Toro 78363 Operator's Manual

1. Remove the mower; refer to Removing the Mower,
page 11.
2. Carefully turn the mower over to expose the blades

Inspecting the Blades

1. Inspect the cutting edges (Fig. 28).
2. If the edges are not sharp or have nicks, remove the
blades and sharpen them.
3. Inspect the blades, especially the curved area (Fig. 28).
4. If you notice any damage, wear, or a slot forming in this
area (Fig. 28), immediately install a new blade.
Figure 28
1. Cutting edge
2. Curved area

Removing the Blade

1. Hold the blade end using a rag or thickly padded glove.
2. Remove the nut, two washers, and blade (Fig. 29).
Note: A block of wood may be wedged between the
blade and the mower to lock the blade when you are
removing the nut.
3. Inspect all parts. If damage is noticed, install new parts.
1
2
3
151
3. Wear/slot forming
16
5
2
1
Figure 29
1. Nut
2. Flat washer—thin
3. Blade
Sharpening a Blade
1. Use a file to sharpen the cutting edge at both ends of the
blade (Fig. 30).
Maintain the original angle. The blade retains its
balance if the same amount of material is removed from
both cutting edges.
1
Figure 30
1. Sharpen at original
angle
2. Check the balance of the blade by putting it on a blade
balancer (Fig. 31).
If the blade stays in a horizontal position, the blade is
balanced and can be used.
1
Figure 31
1. Blade
3. If the blade is not balanced, file some metal off the back
side of the blade.
4. Repeat steps 2 and 3 until the blade is balanced.
4
3
m–3585
4. Washer—thick
5. Spindle
2
2. Balancer