Installing The Mower - Toro 78363 Operator's Manual

Mower Belt Routing
Route the mower belt as shown in Fig. 3. Ensure that you
install the belt on the lower mower deck pulley.
1
Figure 3
Top View
1. Mower belt

Installing the Mower

Preparing the Tractor
Install the mower on a level concrete surface. Rougher dirt
or lawn surfaces make installation more difficult.
1. Position the tractor and mower side by side, with the
mower on the right side of the tractor.
2. Set the parking brake, raise the attachment lift, stop the
engine, and remove the ignition key.
3. If you have previously had a snowthrower, blade, or
tiller attached to the attachment lift, remove the two
clevis pins on each side of the attachment lift (Fig. 4).
2
m-3525
2. Mower deck pulley
1
Figure 4
1. Clevis pin
4. Attach the pulley box if it is not already on the tractor
(Fig. 5).
1
7
2
Figure 5
1. Attach-A-Matic latches
2. Pulley box
3. Idler pulley
4. Belt tension release arm
A. Ensure that the latches on the tractor's front
Attach-A-Matic
B. Slide the pulley box into the Attach-A-Matic
latches and seat it.
C. Close the latches.
5
m–3433
2. Hairpin cotter
6
3
4
m–5510
5. Belt tension adjustment
knob
6. Belt tension indicators
7. Attach-A-Matic buttons
(one on each side)
are open.
2
5