Pushing The Machine By Hand - Toro 72116 Operator's Manual

Pushing the Machine by Hand

IMPORTANT: Always push the machine by
hand. Never tow the machine because
transaxle damage may occur.
To Push the Machine
1. Disengage the power take off (PTO) and turn the
ignition key to "OFF" to stop the engine.
2. Move the drive control rod to the "PUSH"
position. This disengages the drive system and
allows the wheels to turn freely (Fig. 16).
To Operate the Machine
1. Move the drive control rod to the "OPERATE"
position (Fig. 16).
Note: The machine will not drive unless the
drive control rod is in the "OPERATE"
position.
1
2
Figure 16
1. Operate position
2. Push position
3
3. Drive Control Rod
Operation
21