Toro 04520 Operator's Manual page 28

1
1. Reel motor
2. Spline shaft
7. Mount a grass basket onto the basket hooks on the
suspension arm.
8. Repeat this procedure for the other cutting units.
Removing the Cutting Units
1. Park the machine on a clean level surface, lower
the cutting units to the ground until the suspension
hydraulics are fully extended, stop the engine, and set
the parking brake.
2. Push the motor retaining bar out of the slots on the
motor towards the cutting unit and remove the motor
from the cutting unit.
2 3
Figure 31
3. Cavity
4. Motor-retaining bar
4
1
1. Reel motor
3. Move the motor to the storage location on the front of
the suspension arm
g014690
Note: When sharpening, setting the height-of-cut,
or performing other maintenance procedures on the
cutting units, store the cutting unit reel motors in the
storage location on the front of the suspension arms to
prevent damage to them.
Important: Do not raise the suspension to the
transport position when the reel motors are in the
holders in the machine frame. Damage to the
motors or hoses could result. If you must move the
traction unit without the cutting units installed,
secure them to the suspension arms using cable
ties.
4. Open the latches on the suspension-arm bar of the
cutting unit you are removing
5. Disconnect the latches from the cutting-unit bar.
6. Roll the cutting unit out from under the suspension
arm.
7. Repeat steps
as required.
28
2
Figure 32
2. Motor-retaining bar
(Figure 33).
Figure 33
(Figure 29).
2 through 6 for the other cutting units
g014605
g014608