Toro 04520 Operator's Manual page 27

Installing the Cutting Units
1. Lift up on the foot rest and swing it open, allowing
access to the center cutting unit position
CAUTION
The foot rest can pinch fingers if it falls into
the closed position.
Keep your fingers clear of the area where the
foot rest seats while it is open.
1
Figure 28
1. Footrest—closed
2. Position the cutting unit under the center suspension
arm.
3. With the latches on the suspension-arm bar pointing
up (i.e., open) (Figure
down so that the bar fits over the bar across the top of
the cutting unit (Figure
1
Figure 29
1. Latch—closed position
2. Suspension-arm bar
(Figure
2
2. Footrest—open
29), push the suspension arm
30).
2
3. Latch—open position
28).
1
2
1. Suspension-arm bar
g014602
4. Close the latches down and around the cutting-unit bar
and lock them in place
Note: A "click" can be heard and felt when the latches
are properly locked in place.
5. Coat the spline shaft of the cutting unit motor with
clean grease
6. Insert the motor into the left side of the cutting unit
(as viewed from the operator's position) and pull the
motor retaining bar on the cutting unit toward the
motor until you hear an audible "click" from both sides
of the motor
3
g014609
27
Figure 30
2. Cutting-unit bar
(Figure 29).
(Figure 31).
(Figure 31).
g01461 1