Charging The Battery; Insert The Button In The Electric Starter - Toro 20332 Operator's Manual

3. Wipe the dipstick clean with a clean cloth.
4. Insert the dipstick fully into the oil-fill tube, then
remove the dipstick.
5. Read the oil level on the dipstick (Figure 5).
•
If the oil level is below the Add mark on the
dipstick, slowly pour a small amount of oil into
the oil-fill tube, wait 3 minutes, and repeat steps 3
through 5 until the oil level on the dipstick is at
the Full mark.
•
If the oil level is above the Full mark on the
dipstick, drain the excess oil until the oil level
on the dipstick is at the Full mark. Refer to
Changing the Engine Oil (page 15).
Important: If the oil level in the crankcase is too
low or too high and you run the engine, you may
damage the engine.
6. Install the dipstick securely.
Important: Change the engine oil after the first 5
operating hours ; change it yearly thereafter. Refer
to Changing the Engine Oil (page 15).
4

Charging the Battery

No Parts Required
Procedure
Electric-start model only
Refer to Charging the Battery (page 16).
5
Insert the Button in the Electric
Starter
No Parts Required
Procedure
Electric-start model only
Press the button into the electric starter.
Note: Press firmly on the lower part of the button (Figure 6)
until it clicks into place.
7
G020 325
Figure 6