Setup; Installing The Handle - Toro 20332 Operator's Manual

117–2718

Setup

Important: Remove and discard the protective plastic
sheet that covers the engine.
1

Installing the Handle

No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove the handle knobs from the machine housing
(Figure 3).
Important: Route the cables to the outside of the
handle knobs as you install the handle.
5