Installing The Grass Collector - Toro 70185 Setup Instructions

5
Assembling the Grass
Collector
Parts needed for this procedure:
1 Frame
1 Fabric bag with clips
1 Handle
2 Locknuts, M8
4 Washers, M9
Procedure
1. Slide the bag onto the frame and secure it with the
clips (Figure 5).
1. Bag
2. Secure the handle to the bag assembly with 4 washers
(M9) and 2 locknuts (M8) (Figure 6).
1. Bag assembly
2. Handle
Figure 5
2. Frame
Figure 6
3. Washer (M9)
4. Locknut (M8)
6

Installing the Grass Collector

Parts needed for this procedure:
2 Z-brackets
2 Bolts, M6 x 35 mm
2
Spacers
2 Washers
2 Nuts, M6
1 Grass collector cover
2 Pins
1 Full bag lever
Procedure
1. Reach beneath the rear of the tractor and hold the
full bag switch and switch plate while removing the 2
screws on the rear panel (Figure 7).
1. Rear panel
2. Switch
3. Switch plate
2. Hold the switch plate against the switch and slide
the full bag lever into the rectangular slot on the
rear panel.
3. Hook the switch plate onto the lever and secure the
switch and switch plate to the rear panel with the
2 screws (Figure 7).
4. Attach the grass collector to the rear of the tractor
with 2 bolts (M6 x 16.2 mm), Z-brackets, spacers,
washers, and nuts (M6) (Figure 8).
4
Figure 7
4. Full bag lever
5. Screw