Maintenance; Lubrication; Servicing The Bedbar - Toro 03911 Operator's Manual

Maintenance

Lubrication

Each cutting unit has (4) grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base Grease.
The lubrication points are the front roller (2) and the rear
roller (2). Also, after every 250 hours or whenever the reel
motor is removed from the cutting unit, apply grease to the
spline insert (Figure 24).
Note: Lubricating cutting units immediately after
washing helps purge water out of bearings and increases
bearing life.
1. Wipe each grease fitting with a clean rag.
2. Grease the fittings and spline insert.
3. Wipe excess grease away.
Figure 24
Grease fitting locations shown for left side

Servicing the Bedbar

Removing the Bedbar
1. Turn bedbar adjuster screws counterclockwise to back
the bedknife away from reel (Figure 25).
1. Bedbar adjusting screw
2. Spring tension nut
2. Back out the spring tension nut, until the washer is no
longer tensioned against the bedbar (Figure 25).
3. On each side of the machine, loosen the locknut
securing the bedbar bolt (Figure 26).
1. Bedbar bolt
g020156
4. Remove each bedbar bolt allowing bedbar to be pulled
downward and removed from machine bolt (Figure
26). Account for 2 nylon and 1 stamped steel washers
on each end of bedbar (Figure 27).
1. Bedbar bolt
2. Nut
Assembling the Bedbar
1. Install bedbar, positioning mounting ears between
washer and bedbar adjuster.
2. Secure bedbar to each side plate with bedbar bolts
(nuts on bolts) and 6 washers. A nylon washer is to be
positioned on each side of side plate boss. Place a steel
18
Figure 25
3. Bedbar
4. Washer
Figure 26
2. Lock nut
Figure 27
3. Steel washer
4. Nylon washer