Adjusting The Height Of Cut - Toro 03911 Operator's Manual

Adjusting the Height of Cut

Note: For heights of cut greater than 2.54 cm (1.000 inch)
the High Height of Cut Kit must be installed.
1. Loosen locknuts securing height-of-cut brackets to
cutting unit side plates (Figure 16).
Figure 16
1. Adjusting screw
2. Locknut
2. Loosen nut on gauge bar (Figure 17) and set adjusting
screw to desired height-of-cut. Distance between
bottom of screw head and face of bar is height-of-cut.
Figure 17
1. Gauge bar
2. Height adjusting screw
3. Nut
3. Hook the screw head on cutting edge of bedknife and
rest rear end of bar on rear roller (Figure 18).
4. Rotate the adjusting screw until the front roller contacts
the gauge bar (Figure 18). Adjust both ends of roller
until entire roller is parallel to the bedknife.
g020166
3. Height-of-cut bracket
4. Holes used for setting
Groomer HOG
5. Hole not used
Important: When set properly, the rear and front
rollers will contact the gauge bar and the screw
will be snug against the bedknife. This ensures
that the height-of-cut is identical at both ends of
the bedknife.
5. Tighten nuts to secure adjustment. Do not overtighten
nut. Tighten enough to remove play from washer.
Use the following chart to determine which bedknife is
best suited for the desired height of cut.
13
Figure 18