Installing The Starter Rope; Before Starting; Filling The Crankcase With Oil - Toro 20487 Operator's Manual

Super recycler walk power lawn mower

Hide thumbs Also See for 20487:

Service manual (144 pages)

Table Of Contents

Table of Contents

3. Move the handle latches slightly outward to allow the

handle to freely pivot backward into the operating

position (Fig. 3).

Figure 3

1. Cable tie

2. Handle latch

WARNING

POTENTIAL HAZARD

Folding or unfolding the handle improperly can

pinch, stretch, or damage one or more of the

cables.

WHAT CAN HAPPEN

Any pinched, stretched, or damaged cable may

cause an operational failure that results in an

unsafe operating condition.

HOW TO AVOID THE HAZARD

Do not pinch, stretch, or damage the cables.

Handle the cables with care when folding or

unfolding the handle.

Do not use the lawn mower if one or more of

the cables are pinched, stretched, or damaged.

Contact your Authorized Service Dealer.

4. Pivot the handle backward.

5. Move the handle latches inward while snapping the

handle stud into the center hole of the handle latch

(Fig. 3).

Note: If a handle latch does not fit tightly against the

handle tube, remove the latch from the handle stud, bend

the latch inward, and attach it to the handle stud. Repeat

as necessary to ensure a tight fit between the latch and the

handle.

6. Tighten the handle knobs securely.

Note: If handle height is not satisfactory, adjust it by

placing the handle stud into a different hole.

311

3. Handle stud

4. Control Cable

7. Make sure that the control cables are to the rear and

inside of the handles and secure the cables to the

handle with cable ties (Fig. 3).