Removing From Storage; Accessories - Toro 20487 Operator's Manual

4. Check the condition of the blade. Refer to Maintaining
the Blade on page 20.
5. Tighten all nuts, bolts, and screws.
6. Lubricate the wheels. Refer to Lubricating the Lawn
Mower on page 19.
7. Touch up all rusted or chipped paint surfaces with
paint available from an Authorized Service Dealer.

Removing from Storage

1. Check and tighten all fasteners.
2. Remove the spark plug (Fig. 8) and spin the engine
rapidly using the starter to remove the excess oil from
the cylinder.
3. Clean the spark plug or replace it if it is cracked,
broken, or if the electrodes are worn.
4. Install the spark plug and torque it to 14 ft-lb
(19 N m).
5. Perform the recommended maintenance procedures;
refer to Maintenance on page 15.
6. Fill the fuel tank (Fig. 6) with fresh gasoline.
7. Check the engine oil level. Refer to Checking the
Engine Oil Level on page 16.
8. Connect the wire onto the spark plug.

Accessories

You may purchase the following accessories for your lawn
mower from an Authorized Service Dealer:
Rear Bag Kit—Install the discharge tunnel and rear
mounting grass bag to convert your Recycler lawn
mower into a rear-bagging lawn mower (Fig. 31).
Includes the discharge tunnel plug.
1. Discharge tunnel
Side Discharge Kit—Installs in seconds. It is rear
mounted in place of the grass bag or the discharge
tunnel plug. It disperses clippings while trimming on
both sides (Fig. 32).
1. Side discharge chute
Dethatcher Kit—Installs in minutes. It is
front-mounted for easy maneuverability (Fig. 33). The
spring tines loosen thatch for clean and convenient
vacuuming into the grass bag.
25
1
2
Figure 31
2. Discharge tunnel plug
Figure 32
1915
2047