Installing The Carrier Frame - Toro 30555 Operator's Manual

2. Jack up the machine until the front wheel is off of the
floor. Use jack stands or block the machine to prevent
it from accidentally falling.
3. Remove the wheel nuts and slide the wheel and tire
assembly off of the studs.
4. Mount a lift arm to the pivot bracket with 2 spacers,
a pivot pin, and a cotter pin (5/32 x 1-3/4 inches).
Mount the lift arm with the bend positioned outward
(Figure 2).
4
1
Figure 2
1. Lift arm
2. Spacer (2)
5. Mount the rear of the lift arm to the lift cylinder with a
pivot pin and 2 cotter pins (supplied with the traction
unit) (Figure 3).
3
Figure 3
1. Cylinder pin
2. Cylinder end
6. Remove the cotter pins from the clevis pins holding
the brake struts and yokes together, and discard the
cotter pins. Keeping the clevis pin in place, install the
short end of the spring into the hole in the clevis pin to
retain the parts together. Connect the other end of the
springs to the slotted holes in the lift arms (Figure 4).
3
2
2
G010540
3. Pivot bracket
4. Pivot pin
1
3
2
G010541
3. Cotter pin
1. Brake return spring
7. Repeat the procedure on the opposite side of the
machine.
2

Installing the Carrier Frame

Parts needed for this procedure:
2 Rear cradle
2 Spacer
6 Bolt (3/8 x 2 inches)
6 Flange nut (3/8 inch)
3 Bolt (1/2 x 1-1/2 inches)
Procedure
Note: Grease the castor wheel shaft with No. 2 grease after
installing and after initial operation of the machine.
1. Carrier frame is shipped upside down. Turn frame
over before installation.
2. Remove the lynch pin and 2 thrust washers shipped on
each castor wheel assembly. Leave 2 thrust washers on
each shaft, insert the shafts into the frame mounting
tube, and install the thrust washers and lynch pin
(Figure 5).
9
1
2
Figure 4
2. Slotted hole
G010542