Product Overview; Specifications; Attachments/Accessories; Operation - Toro 30555 Operator's Manual

Product Overview

Specifications

Note: Specifications and design are subject to change
without notice.
Width of 1.314 m (51-3/4 inches )
Cut
Height Adjustable from 25 to 102 mm (1 to 4 inches) in 1/2
of Cut inch (13 mm) increments
Blade 15,525 ft/minute @ 3250 engine RPM
Tip
Speed
Cutting 3 heat-treated steel blades, each 4.8 mm (3/16 inch)
Blades thick and 457 mm (18 inches) long
Pneumatic 203 mm (8 inches) diameter greaseable roller
Wheels bearings (inflated to 138-207 kPa [20-30 psi])
Drive PTO driven gear box transmits power through a "AA"
System section belt to all blade spindles.
Net 153 kg (338 lbs.)
Weight

Attachments/Accessories

A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.

Adjusting the Height-of-Cut

The height-of-cut is adjustable from 25 to 102 mm (1 to 4
inches) in 13 mm (1/2 inch) increments by relocating 4 clevis
pins in different hole locations (Figure 11).
1. 25 mm (1 inch)
2. 38 mm (1-1/2 inches)
3. 51 mm (2 inches)
4. 64 mm (2-1/2 inches)
5. 76 mm (3 inches)

Adjusting the Rollers

Note: If the cutting unit is to be used in the 25 mm (1 inch)
or 38 mm (1-1/2 inches) height-of-cut setting, the rear cutting
unit rollers must be repositioned in the top bracket holes.
1. Remove the cotter pins securing the roller shafts to
the underside of the deck.
2. Slide the shafts out of the lower bracket holes, align the
rollers with the top holes, and install the shafts.
3. Install the cotter pins to secure the assemblies.
12
Figure 11
6. 89 mm (3-1/2 inches)
7. 102 mm (4 inches )
8. Grass deflector
9. Spring hinges