Installing The Castor Wheels; Installing The Carrier Frame To The Traction Unit - Toro 30138 Operator's Manual

Installation

Installing the Castor Wheels

1. Place two (2) thrust washers onto the castor
wheel fork (Fig. 1).
2. Insert the castor wheel fork into the carrier frame
mounting tube (Fig. 1).
3. Install the spacer and two (2) thrust washers onto
the castor wheel fork, then secure with a
retaining ring (Fig. 1).
1
4
3
5
Figure 1
1. Retaining Ring
2. Thrust Washer (4)
3. Carrier Frame Mounting
Tube
4
2
2
4. Spacer
5. Castor Wheel Fork
Installing the Carrier Frame to
the Traction Unit
1. Align the carrier frame holes with the mounting
holes in the traction unit frame (Fig. 2).
2. Fasten each side of the carrier frame to the
traction unit with three (3) 1/2" x 25 mm (1")
flange screws and locknuts. Torque the mounting
screws to 81–109 N m (60–80 ft-lb) (Fig. 2).
2
1
Figure 2
1. Carrier Frame 2. Traction Unit Frame