Table of Contents
Advertisement
positions: Engage and Disengage. Pull up on the lever
to engage the reel or push it down to disengage the reel.
1. Reel drive lever
Choke Lever
The choke lever (Figure 8) is located on left front of the
engine. The lever has two positions: Run and Choke.
Move the lever to the Choke position when starting
a cold engine. After engine starts move lever to Run
position.
1. Choke lever
Fuel Shut-Off Valve
The fuel shut-off valve (Figure 8) is located on left
front of engine. The valve has two positions: Closed
and Open. Move the lever to the closed position when
storing or transporting machine. Open the valve before
starting the engine.
On/Off Switch
The on/off switch (Figure 9) is located on the top of the
control panel. Move switch to the On position to start
the engine and the Off position to stop the engine.
Figure 7
Figure 8
2. Fuel shut-off valve
Recoil Starter
Pull recoil starter handle (Figure 9) to start engine.
1. Recoil starter
2. Kick stand
Kickstand (Optional)
The kickstand (Figure 9) is mounted to the rear of
machine and is used to raise the rear of machine for
installation or removal of the transport wheels.
Specifications
Width
Height
Length with basket
Dry weight (with basket and
Wiehle roller; without wheels
or grooming reel)
Width of cut
Height of cut
Clip
Attachments/Accessories
A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
12
Figure 9
3. On/off switch
36 inches (91 cm)
47 inches (119 cm)
59 inches (150 cm)
208 lb (94 kg.)
21 inches (53 cm)
5/64 to 1 inch (0.2 to 2.5 cm)
0.16 inch (0.4 cm)
Advertisement
Table of Contents
