Troubleshooting - Toro 53002 Operator's Manual

POTENTIAL HAZARD
Without the Brushcutter blade shield
installed on the String Trimmer, the
Brushcutter blade can throw foreign
objects.
Without the correct blade shield, handles
and strap installed on the String Trimmer,
the Brushcutter can produce side thrust
which can expose the operator and
bystanders to blade contact.
WHAT CAN HAPPEN
Contact with the Brushcutter blade or
thrown objects can cause severe personal
injury.
HOW TO AVOID THE HAZARD
Never install only a Brushcutter blade onto
a String Trimmer.
To convert a String Trimmer to a
Brushcutter, you must purchase and install
the entire Brushcutter Accessory Kit.

Troubleshooting

Problem
Engine Will Not Start
Engine Will Not Idle
Engine Lacks Power or Stalls When
Cutting Cutting
If further assistance is required, contact your local authorized Toro service dealer.
16
2. Brushcutter Accessory Kit, Model No.
53050—allows you to convert the String
Trimmer to a Brushcutter; available for
Industrial Models (53002 and 53003) only.
Cause
STOP switch set to off position
Empty fuel tank
Primer bulb wasn't pushed enough
Engine flooded
Idle speed set incorrectly
Throttle wire has come loose
Dirty air filter
Action
Move switch to on position
Fill fuel tank
Press primer bulb until fuel flows
through fuel return line
Use warm engine starting
procedure
Set idle speed
Tighten throttle wire
Clean or replace air filter