Specifications - Makita DFS452 Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Capacities
Overall length
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
Cd Only for EU countries
Ni-MH
Do not dispose of electric equipment or
Li-ion
battery pack together with household
waste material!
In observance
Directives, on Waste Electric and
Electronic Equipment and Batteries and
Accumulators and Waste Batteries and
Accumulators and their implementation
in accordance with national laws,
electric equipment and batteries and
battery pack(s) that have reached the
end of their life must be collected
separately
environmentally compatible recycling
facility.
Intended use
The tool is intended for screw driving in wood, metal
and plastic.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Model
Self drilling screw
Drywall screw
No load speed
With short locator
With long locator
Net weight
Rated voltage
of the
and returned
noise level determined
) : 72 dB (A)
pA
END004-6
Vibration
The vibration
determined according to EN60745:
Work mode: screwdriving without impact
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
European
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
to an
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
ENE033-1
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG905-1
2
DFS452
6 mm
5 mm
-1
0 - 4,000 min
235 mm
251 mm
1.7 kg
D.C. 18 V
total value (tri-axial
2
) : 2.5 m/s or less
h
2
ENG900-1
vector sum)
ENG901-1