Yamaha CDR1000 Service Manual page 11

4. CRW Unit
4-1. Remove the four (4) screws marked [250], and the
angle can be removed.
4-2. Remove the two (2) screws marked [A] and push in
the four (4) hooks on both side.
Then the cover can be removed.
4-3. Remove the front panel marked [220a] of the unit
and then the tray marked [220b].
Push up the stopper located on the left side of the
tray a little, and the tray can be removed.
[100] [60]
[100]
[100] [120]
[320]
[130]
[260]
CRW Unit
[320]
[260]
[320]
[300]
[300]
[110] [100] [190]
[530]
[100]
[180] [530]
[320]
[150]
MAIN
PS
[160]
[160]
[130]
[160]
Power
Transformer
[150]
[260]
[130] [280] [300]
[320] [300]
Fig.1
〈 TOP VIEW 〉
〈 FRONT VIEW 〉
[320]
[320]
[300]
[160] [120]
[120]
FP 1/7
FP 3/7
[120]
[160] [90] [90] [80]
[30]
FP 7/7
[60]
[50] FP 6/7
〈 A VIEW 〉
Fig.2
Cover
Stopper pin
Front panel [220a]
Tray [220b]
Tray panel [230]
Fig.3
CDR1000
[160]
[70] [200] [190]
[120]
FP 4/7 FP 7/7
FP 2/7
FP 5/7 FP 6/7
[120]
[80] [160]
[40]
FP 4/7
FP 6/7
〈 B VIEW 〉
[A]
CDR angle [240]
[250]
9