Advertisement
Now we need to prepare main wing support. Here you can see reinforcement piece made from
0.5mm fiberglass. In your Arrow kit you will find similar detail, glue it in center of wing on
bottom of fuselage.
Mark 23 cm distance (measuring from fuselage towards wingtip). This will be point where
wing support from 1.5mm will be connected. Wing support carbon rod must be 26 cm long.
Also don't forget to use credit card to make sure fuselage is always stand by 90 degree angle.
DO NOT GLUE 4 carbon rods in center yet. First you need to attach them to flat carbon that is
glued to leading and back edge of main wing.
Glue four carbon rods to main wing, and as shown using needle and kevlar thread make
couple loops around carbon spar and flat carbon. This will give amazing strenght when you
will place drop of foam friendly CA glues on top. This update will keep wings in same position
no matter how hard you will fly your plane.
8
Advertisement
