Advertisement
Last surface left to do is rudder. Same as with elevator i recommend to use pull pull system to
control it. Same ass with elevator i recommend "8" hinging method. In order to have smooth
movement, ussing sanding paper make edge of elevator round. Also very important upgrade for
rudder strenght and long life is piece of thin flat carbon going from compensator to middle of
Ussing foam friendly CA glues attach triangle piece to rudder as shown in picture. Make sure
triangle piece is „connected" to reinforcement carbon. Latter glue in 45mm x1,5mm carbon rod, in
the holle close to bending edge, make sure distance on both sides is equal.
Here you can see 40mm x 1.5mm carbon
rod installed to elevator. It must be
exactly
same lenght on both sides.
Cable that is providet with kit will work
fine, but same as with ball links i preffere
to use slightly different material for my
competition models. I use 5KG fishing
line, and on top of the line i wind kevlar
threat. Togetheer they provite extremely
good control with no „spring effect" ,
also tension stay the same no matter
what weather you have.
14
Advertisement
