Advertisement
Optional reinforcement:
in picture, this give very good strenght for elevator and prevent stabilizer part from cracking.
Glue 0.5mm carbon on back and leading edges of the wing. Carbon lenght required for back edge
is 70cm, for front we will need 83cm carbon lenght should be. Very end of carbon is fixed with
small piece of medical blenderm tape.
When flat carbon is glued to wing, and aileron edges are beveled, its time to attach these two parts
together. I highly recommend to use 3M medical blenderm tape, it stick extremely well to depron
surface. Also this tape is not shiny so it does not stand out and change colour sheme of the plane.
In picture on right you can see black circles, these are areas where small pieces of blenderm tape
must be placed. Reinforcement here prevent aileron from moving away from wing, after many
hours of flying.
Glue thin carbon (that is left from „shaving" main carbon spar ) like shown
4
Advertisement
