Philips 40PFK6580 User Manual page 93

In certain countries, the automatic channel update is
done while watching TV or on any moment when the
TV is in Standby.
Manual Channel Update
You can always start an channel update yourself.
To start a channel update manually...
1 - Press  , select All Settings and press OK.
2 - Select Channels > Satellite Installation and
press OK.
3 - Select Search for Channels and press OK.
4 - Select Update Channels and press OK. The TV
will start updating. The update may take a few
minutes.
5 - Follow the instructions on screen. The update
may take a few minutes.
6 - Select Finish and press OK.
Add a Satellite
You can add an additional satellite to your current
satellite installation. The installed satellites and their
channels remain untouched. Some satellite operators
do not allow adding a satellite.
The additional satellite should be seen as an extra, it
is not your main satellite subscription or not the main
satellite of which you use its channel package.
Typically, you would add a 4th satellite when you
have 3 satellites already installed. If you have 4
satellites installed, you might consider removing one
first to be able to add a new satellite.
Setup
If you currently have only 1 or 2 satellites installed, the
current installation settings might not allow adding an
extra satellite. If you need to change the installation
settings, you must redo the complete satellite
installation. You cannot use Add satellite if a change
of settings is needed.
To add a satellite...
1 - Press  , select All Settings and press OK.
2 - Select Channels > Satellite Installation and
press OK.
3 - Select Search for satellite and press OK.
4 - Select Add Satellite and press OK. The current
satellites are shown.
5 - Select Search and press OK. The TV will
search for new satellites.
6 - If the TV has found one or more satellites,
select Install and press OK. The TV installs the
channels of the found satellites.
7 - Select Finish and press OK to store the
channels and radio stations.
Remove a Satellite
You can remove one or more satellites from your
current satellite installation. You remove the satellite
and its channels. Some satellite operators do not
allow removing a satellite.
To remove satellites...
1 - Press  , select All Settings and press OK.
2 - Select Channels > Satellite Installation and
press OK.
3 - Select Search for satellite and press OK.
4 - Select Remove Satellite and press OK. The
current satellites are shown.
5 - Select a satellite and press OK to mark or
unmark them to remove.
6 - Press  (left) repeatedly if necessary, to close
the menu.
Manual Installation
Manual Installation is intended for expert users.
You can use Manual Installation to quickly add new
channels from a satellite transponder. You need to
know the frequency and polarization of the
transponder. The TV will install all channels of that
transponder. If the transponder was installed before,
all its channels - the former and the new ones - are
moved to the end of the channel list All.
You cannot use Manual installation if you need to
change the number of satellites. If this is needed, you
have to do a complete installation with Install
Satellites.
To install a transponder...
1 - Press  , select All Settings and press OK.
2 - Select Channels > Satellite Installation and
press OK.
3 - Select Manual Installation and press  (right)
to enter the menu.
4 - If you have more than 1 satellite installed, select
LNB for which you want to add channels.
5 - Set the Polarisation you need. If you set
the Symbol Rate Mode to Manual, you can enter
the symbol rate in Symbol Rate manually.
6 - Press the arrows  (up) or  (down) to adjust
the frequency, and select Done.
7 - Select Search and press OK. The signal
strenght is shown on screen.
8 - If you want to store the channels of a new
transponder, select Store and press OK.
9 - Press  (left) repeatedly if necessary, to close
the menu.
93