Switching On And Off; On Or Standby; Philips Logo Brightness; Keys On Tv - Philips 40PFK6580 User Manual

5
Switching On and
Off
5.1

On or standby

Make sure the TV is connected to the mains AC
power. Connect the supplied power cord to the AC
in connector at the back of the TV. The indicator light
at the bottom of the TV lights up.
Switch on

Press on the remote control to switch the TV
on. Alternatively, press  HOME. You can also
press the small joystick key on the back of the TV to
switch the TV on in case you can't find the remote
control or its batteries are empty.
Switch to standby
To switch the TV to standby, press
control. You can also press the small joystick key on
the back of the TV.
In standby mode, the TV is still connected to the
mains power but consumes very little energy.
To switch off the TV completely, disconnect the
power plug.
When disconnecting the power plug, always pull the
power plug, never the cord. Ensure that you have full
access to the power plug, power cord and outlet
socket at all times.
5.2

Philips Logo Brightness

You can switch off or adjust the brightness of the
Philips logo on the front of the TV.
To adjust or switch off...
1 - Press  , select All Settings and press OK.
2 - Select General Settings and press  (right) to
enter the menu.
3 - Select Philips Logo Brightness, and
press  (right) to enter the menu.
4 - Select Minimum, Medium, Maximum,
or Off to switch off the lighting of the logo, then
press OK.
5 - Press  (left) repeatedly if necessary, to close

on the remote
26
the menu.
5.3

Keys on TV

If you lost the remote control or its batteries are
empty, you can still do some basic TV operations.
To open the basic menu...
1 - With the TV switched on, press the joystick key on
the back of the TV to bring up the basic menu.
2 - Press left or right to select  Volume, 
Channel or  Sources. Select  Demo, to start a
demo movie.
3 - Press up or down to adjust the volume or tune to
the next or previous channel. Press up or down to go
through the list of sources, including the tuner
selection. Press the joystick key to start the demo
movie.
4 - The menu will disappear automatically.
To switch the TV on standby, select  and press the
joystick key.
5.4

Sleep Timer

With the Sleep Timer, you can set the TV to switch to
Standby automatically after a preset time.
To set the Sleep Timer...
1 - Press  , select Sleep Timer and press OK.
2 - With the slider bar you can set the time to up to
180 minutes in increments of 5 minutes. If set to 0
minutes, the Sleep Timer is switched off. You can
always switch off your TV earlier or reset the time
during the countdown.
3 - Press  BACK to close the menu.