Table of Contents
Advertisement
3
Installation
Transportation
Instructions
1. The appliance should be
transported only in a vertical upright
position. The packing as supplied
must be intact during transportation.
2. If during the course of
transport the appliance has to be
transported horizontally, it must only
be laid on its right hand side when
standing in the frontof the appliance.
After bringing it to upright position,it
must not be operated for at least 4
hours to allow the system to settle.
3. Failure to comply with the
above instructions could result in
damage occuring to the appliance.
The manufacturer will not be held
responsible if these instructions are
disregarded.
4. The appliance must be
protected against rain, moisture and
other atmospheric influences.
5. When positioning your
appliance take care not to damage
your flooring, pipes, wall coverings
etc. Do not move the appliance by
pulling by the door or handle.
6. Empty any water in the drain
tray before moving. See section
'Defrosting' and 'Care & cleaning' for
further information.
7. Make sure that the defrost
water pipe at the back of the product
is fixed to the plastic evaporating pan
on the top of the compressor, to avoid
defrost water spillage on the floor.
8. The appliance must be
protected against rain, moisture and
other atmospheric influences.
9. The distance between ball wall
and the back of refrigerator can not
be bigger than 75 mm.
"Important: Care must be taken
while cleaning / carrying the
appliance to avoid touching the
bottom of the condenser metal wires
at the back of theappliance as you
might injure your fingers and hands.
"Important: This appliance is not
designed for stacking with any
otherappliance.When positioning
your appliance, take care not to
damage your flooring, pipes,wall
coverings etc.
"Important: Care must be taken
while cleaning / carrying the appliance
to avoid touching the bottom of the
condenser metal wires at the back of
the appliance as you might injure your
fingers and hands.
Do not attempt to sit or stand on top
of your appliance as it is not designed
for such use. You could injure yourself
or damage the appliance.
"Important: Make sure that mains
cable is not caught under the appliance
during and after carrying / moving
the appliance, to avoid the mains
cable becoming cut or damaged."Do
not allow children to play with the
appliance or tamper with the controls.
Beko declines to accept any liability
should
the
followed.
11
EN
instructions
not
be
Advertisement
Table of Contents
