Page 1
Thank you for purchasing our product. We hope this user-friendly device will be helpful in realising your ideas and bringing comfort to your life. Please take few minutes to read this manual before starting to work with VRT012 . This would make the installation and use of device easier.
Page 2
If a match is found, it means the caller is an authorized person. Due to this VRT012 will turn ON its’ output, in short, sending a signal to activate the connected device. VRT012 does not have any answer function;...
Page 3
D E S C R I P T I O N O F T H E D E V I C E A N D P R I N C I P L E S O F F U N C T I O N I N G The device VRT012 consists of a microcontroller and GSM modem. The microcontroller receives and processes signals.
Page 4
When the Power is supplied, the device checks the whole internal data base of numbers and operation of the memory chip. If there is a memory error, the device would not switch to operation mode and 2 pulses would be emitted by alternately by the light diode Signal Strength. If the GSM modem is not functioning, the device would not switch to operation mode and uninterrupted swift short pulses would be emitted by the light diode Signal Strength.
Page 5
After the device is switched on and configured, it is ready for use. When the device is turned on for the first time, please see if it is properly switched on. One only needs to watch the signals of the light diodes: if the device is switched on properly, the signals of the light diodes would be activated as specified in the table.
Page 6
Example: P#1=+37069854788; - this message means that the number +37069854788 must be recorded in the first (1) position. SMS message containing a command for recording the time of the delay of the relay is as follows: PRTIMT=xxxxx; The symbol “P” should be in the first position, xxxxx means the recorded time in miliseconds within which the relay would be delayed.
Page 7
C O N F I G U R A T I O N B Y M E A N S O F A P E R S O N A L C O M P U T E R In order to configure the device using a personal computer you should: Install Remote Switch Configurator • Connect VRT012 to a PC using a configuratin cable • Start Remote Switch Configurator •...
Page 8
Start working with Remote Switch Configurator by configuring port – Configure Port. A port configuration window is shown in picture 5. You should select a Port which a device VRT012 is connected to and press Ok. Picture 5. Port Configuration Window.
Page 9
The sign on the packaging means that the electric and electronic equipment to be utilised must be stored separately. A N D L A S T … In case you have problems with the installation and use, please address them to the Technical Assistance Department by e-mail support@teltonika.lt.
Need help?
Do you have a question about the VRT012 and is the answer not in the manual?
Questions and answers